|
Boring Bar
|
12-22-2019, 06:42 PM
(12-21-2019, 01:09 PM)Dr Stan Wrote: What is the finished diameter and the length of the hole? I have to take out 1/2” at a depth of 1” with no shoulder at the bottom. And 5/8” at a depth of 1/2” up to a shoulder at the bottom
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Boring Bar - by Cross Slide - 12-21-2019, 10:19 AM
RE: Boring Bar - by EdK - 12-21-2019, 11:49 AM
RE: Boring Bar - by Cross Slide - 12-21-2019, 12:22 PM
RE: Boring Bar - by Highpower - 12-21-2019, 12:41 PM
RE: Boring Bar - by Cross Slide - 12-22-2019, 06:37 PM
RE: Boring Bar - by Highpower - 12-22-2019, 10:45 PM
RE: Boring Bar - by Cross Slide - 12-23-2019, 09:46 PM
RE: Boring Bar - by Dr Stan - 12-21-2019, 01:09 PM
RE: Boring Bar - by Cross Slide - 12-22-2019, 06:42 PM
RE: Boring Bar - by rleete - 12-21-2019, 02:26 PM
RE: Boring Bar - by TomG - 12-23-2019, 09:46 AM
RE: Boring Bar - by Cross Slide - 12-23-2019, 09:50 PM
RE: Boring Bar - by TomG - 12-23-2019, 10:53 PM
RE: Boring Bar - by rleete - 12-23-2019, 07:56 PM
RE: Boring Bar - by Highpower - 12-23-2019, 08:49 PM
RE: Boring Bar - by Dr Stan - 12-24-2019, 12:11 AM
RE: Boring Bar - by Highpower - 12-24-2019, 11:30 AM
RE: Boring Bar - by Dr Stan - 12-24-2019, 12:20 PM
RE: Boring Bar - by Highpower - 12-24-2019, 12:53 PM
RE: Boring Bar - by EdK - 12-24-2019, 12:59 PM
|
