MetalworkingFun Forum › Machinery › Lathes v
Possible problem.

Thread Modes
Possible problem.
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#13
12-22-2019, 02:05 PM
It looks as though the axis of the chuck/part may not be on axis with the lathe spindle. Remove the chuck and check the mounting surface for dirt or burrs. The face of the chuck should also run true if it is mounted correctly.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Possible problem. - by Swarf_Newbie - 12-20-2019, 08:28 PM
RE: Possible problem. - by unioncreek - 12-20-2019, 09:13 PM
RE: Possible problem. - by TomG - 12-20-2019, 09:30 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:01 PM
RE: Possible problem. - by Highpower - 12-20-2019, 10:07 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:18 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 08:42 PM
RE: Possible problem. - by Highpower - 12-21-2019, 09:53 PM
RE: Possible problem. - by Swarf_Newbie - 12-22-2019, 04:43 PM
RE: Possible problem. - by Vinny - 12-20-2019, 10:43 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 12:03 AM
RE: Possible problem. - by Highpower - 12-22-2019, 12:46 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 01:16 PM
RE: Possible problem. - by TomG - 12-22-2019, 02:05 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 04:03 PM
RE: Possible problem. - by Swarf_Newbie - 12-24-2019, 12:53 PM
RE: Possible problem. - by Swarf_Newbie - 10-17-2020, 05:19 PM
RE: Possible problem. - by Dr Stan - 10-18-2020, 08:51 AM
RE: Possible problem. - by Swarf_Newbie - 10-19-2020, 09:49 AM
RE: Possible problem. - by Dr Stan - 10-19-2020, 11:58 AM



Users browsing this thread: 3 Guest(s)