12-21-2019, 12:41 PM
What type of tool post are you using? Square 4-position or QCTP?
What type of boring bars? Like these?
![[Image: HTB1vTqLPVXXXXaJXpXXq6xXFXXXf.jpg]](https://sc01.alicdn.com/kf/HTB1vTqLPVXXXXaJXpXXq6xXFXXXf.jpg)
I find the brazed carbide tools work much better after being ground to a sharp edge and a decent clearance angle. Center height is the correct way to go.
What type of boring bars? Like these?
I find the brazed carbide tools work much better after being ground to a sharp edge and a decent clearance angle. Center height is the correct way to go.
Willie