MetalworkingFun Forum › Machinery › Lathes v
Possible problem.

Thread Modes
Possible problem.
unioncreek Offline
Freshman
**
Posts: 15
Threads: 4
Joined: Jun 2013
Location: Colfax WA
#2
12-20-2019, 09:13 PM
If you get the same results with other stock in the chuck,  I would suspect that maybe the chuck jaws are out of whack.  Thats just a thought hopefully someone else will come along shortly and be able to give you a definite answer.

Bob
Reply
Thanks given by:


Messages In This Thread
Possible problem. - by Swarf_Newbie - 12-20-2019, 08:28 PM
RE: Possible problem. - by unioncreek - 12-20-2019, 09:13 PM
RE: Possible problem. - by TomG - 12-20-2019, 09:30 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:01 PM
RE: Possible problem. - by Highpower - 12-20-2019, 10:07 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:18 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 08:42 PM
RE: Possible problem. - by Highpower - 12-21-2019, 09:53 PM
RE: Possible problem. - by Swarf_Newbie - 12-22-2019, 04:43 PM
RE: Possible problem. - by Vinny - 12-20-2019, 10:43 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 12:03 AM
RE: Possible problem. - by Highpower - 12-22-2019, 12:46 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 01:16 PM
RE: Possible problem. - by TomG - 12-22-2019, 02:05 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 04:03 PM
RE: Possible problem. - by Swarf_Newbie - 12-24-2019, 12:53 PM
RE: Possible problem. - by Swarf_Newbie - 10-17-2020, 05:19 PM
RE: Possible problem. - by Dr Stan - 10-18-2020, 08:51 AM
RE: Possible problem. - by Swarf_Newbie - 10-19-2020, 09:49 AM
RE: Possible problem. - by Dr Stan - 10-19-2020, 11:58 AM



Users browsing this thread: 1 Guest(s)