MetalworkingFun Forum › Machining › How-To's v
Setting the lathe compound

Thread Modes
Setting the lathe compound
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#7
12-11-2019, 06:33 AM
I stuck mine in the ultrasonic when I got them because they were a little cruddy. (eBay)
Clean as a whistle now but it peeled a lot of loose paint off too. Luckily a can of silver hammer finish paint is pretty cheap. Smile
Willie
Reply
Thanks given by:


Messages In This Thread
Setting the lathe compound - by Vinny - 12-10-2019, 02:17 PM
RE: Setting the lathe compound - by Highpower - 12-10-2019, 03:52 PM
RE: Setting the lathe compound - by Vinny - 12-10-2019, 04:06 PM
RE: Setting the lathe compound - by Ed ke6bnl - 12-10-2019, 04:30 PM
RE: Setting the lathe compound - by Highpower - 12-10-2019, 04:33 PM
RE: Setting the lathe compound - by Vinny - 12-11-2019, 01:31 AM
RE: Setting the lathe compound - by Highpower - 12-11-2019, 06:33 AM
RE: Setting the lathe compound - by Vinny - 12-11-2019, 12:09 PM
RE: Setting the lathe compound - by Highpower - 12-11-2019, 02:07 PM



Users browsing this thread: 2 Guest(s)