MetalworkingFun Forum › Machining › How-To's v
Mill or drill??

Thread Modes
Mill or drill??
Paulc Offline
Sophmore
***
Posts: 51
Threads: 11
Joined: Jan 2019
Location: HUMBOLDT, AZ
#4
11-03-2019, 11:26 AM
After fooling with a Chinese boring bar set for half an hour and getting crappy results, I finished it with a 1/2 in drill in the lathe tail stock and the results were very good.
Did a second one by progressively drilling a larger hole after starting with a center drill and that went smoothly as well.
Reply
Thanks given by:


Messages In This Thread
Mill or drill?? - by Paulc - 11-02-2019, 03:15 PM
RE: Mill or drill?? - by EdK - 11-02-2019, 06:30 PM
RE: Mill or drill?? - by Highpower - 11-02-2019, 07:58 PM
RE: Mill or drill?? - by Paulc - 11-03-2019, 11:26 AM
RE: Mill or drill?? - by Highpower - 11-03-2019, 12:19 PM
RE: Mill or drill?? - by EdK - 11-03-2019, 01:06 PM
RE: Mill or drill?? - by Paulc - 11-03-2019, 02:30 PM



Users browsing this thread: 1 Guest(s)