MetalworkingFun Forum › Machining › General Metalworking Discussion v
removing name plates

Thread Modes
removing name plates
Bill Gruby
Unregistered
 
#22
06-30-2012, 05:48 PM
Absolutely hard to drill even with carbide. They are small and if you do manage to get a drill bit started it will walk all over the place. A new hole is the only way I know of. As said these little buggers are hard.

"Billy G" Big Grin
Reply
Thanks given by:


Messages In This Thread
removing name plates - by Mayhem - 06-24-2012, 08:52 PM
RE: removing name plates - by krv3000 - 06-25-2012, 01:58 AM
RE: removing name plates - by TomG - 06-25-2012, 06:53 AM
RE: removing name plates - by Bill Gruby - 06-25-2012, 07:50 AM
RE: removing name plates - by Mayhem - 06-25-2012, 08:03 AM
RE: removing name plates - by f350ca - 06-25-2012, 09:28 AM
RE: removing name plates - by TomG - 06-25-2012, 09:47 AM
RE: removing name plates - by dallen - 06-26-2012, 10:50 AM
RE: removing name plates - by November X-ray - 06-25-2012, 04:25 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 03:14 PM
RE: removing name plates - by starlight_tools - 06-26-2012, 06:45 PM
RE: removing name plates - by Mayhem - 06-26-2012, 05:38 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 05:56 PM
RE: removing name plates - by stevec - 06-26-2012, 05:52 PM
RE: removing name plates - by Mayhem - 06-26-2012, 06:08 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 06:14 PM
RE: removing name plates - by Mayhem - 06-29-2012, 11:26 PM
RE: removing name plates - by DaveH - 06-30-2012, 07:46 AM
RE: removing name plates - by Bill Gruby - 06-30-2012, 08:05 AM
RE: removing name plates - by stevec - 06-30-2012, 05:23 PM
RE: removing name plates - by doubleboost - 06-30-2012, 05:29 PM
RE: removing name plates - by Bill Gruby - 06-30-2012, 05:48 PM
RE: removing name plates - by Mayhem - 06-30-2012, 11:25 PM
RE: removing name plates - by Tony Wells - 06-30-2012, 11:42 PM
RE: removing name plates - by Mayhem - 06-30-2012, 11:46 PM
RE: removing name plates - by Tony Wells - 06-30-2012, 11:51 PM



Users browsing this thread: 5 Guest(s)