MetalworkingFun Forum › Machining › General Metalworking Discussion v
removing name plates

Thread Modes
removing name plates
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#21
06-30-2012, 05:29 PM
I would say not possible
Even using cobalt drillsSlapheadSlaphead
I remember them on BMC engine blocks
They were like hammer in self tappers
I am sure i have some at work
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
removing name plates - by Mayhem - 06-24-2012, 08:52 PM
RE: removing name plates - by krv3000 - 06-25-2012, 01:58 AM
RE: removing name plates - by TomG - 06-25-2012, 06:53 AM
RE: removing name plates - by Bill Gruby - 06-25-2012, 07:50 AM
RE: removing name plates - by Mayhem - 06-25-2012, 08:03 AM
RE: removing name plates - by f350ca - 06-25-2012, 09:28 AM
RE: removing name plates - by TomG - 06-25-2012, 09:47 AM
RE: removing name plates - by dallen - 06-26-2012, 10:50 AM
RE: removing name plates - by November X-ray - 06-25-2012, 04:25 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 03:14 PM
RE: removing name plates - by starlight_tools - 06-26-2012, 06:45 PM
RE: removing name plates - by Mayhem - 06-26-2012, 05:38 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 05:56 PM
RE: removing name plates - by stevec - 06-26-2012, 05:52 PM
RE: removing name plates - by Mayhem - 06-26-2012, 06:08 PM
RE: removing name plates - by Tony Wells - 06-26-2012, 06:14 PM
RE: removing name plates - by Mayhem - 06-29-2012, 11:26 PM
RE: removing name plates - by DaveH - 06-30-2012, 07:46 AM
RE: removing name plates - by Bill Gruby - 06-30-2012, 08:05 AM
RE: removing name plates - by stevec - 06-30-2012, 05:23 PM
RE: removing name plates - by doubleboost - 06-30-2012, 05:29 PM
RE: removing name plates - by Bill Gruby - 06-30-2012, 05:48 PM
RE: removing name plates - by Mayhem - 06-30-2012, 11:25 PM
RE: removing name plates - by Tony Wells - 06-30-2012, 11:42 PM
RE: removing name plates - by Mayhem - 06-30-2012, 11:46 PM
RE: removing name plates - by Tony Wells - 06-30-2012, 11:51 PM



Users browsing this thread: 1 Guest(s)