It could also be accomplished using a fixture with some stop pins assuming one could have a pin hole in the center of the circle. Just make sure you conventional mill, not climb mill.
|
Mill a circle
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill a circle - by Paulc - 10-17-2019, 03:11 PM
RE: Mill a circle - by Highpower - 10-17-2019, 08:06 PM
RE: Mill a circle - by Paulc - 10-17-2019, 08:18 PM
RE: Mill a circle - by Dr Stan - 10-17-2019, 08:57 PM
RE: Mill a circle - by rleete - 10-18-2019, 08:36 AM
RE: Mill a circle - by Paulc - 10-18-2019, 03:11 PM
RE: Mill a circle - by Dr Stan - 10-18-2019, 07:31 PM
RE: Mill a circle - by Highpower - 10-19-2019, 10:48 AM
RE: Mill a circle - by Dr Stan - 10-19-2019, 03:25 PM
RE: Mill a circle - by Highpower - 10-19-2019, 08:00 PM
RE: Mill a circle - by Paulc - 10-19-2019, 03:39 PM
RE: Mill a circle - by Dr Stan - 10-19-2019, 04:36 PM
|
Users browsing this thread: 1 Guest(s)