09-10-2019, 08:31 AM
(09-09-2019, 10:10 PM)Vinny Wrote: The bearings showed up today - YAY!!! Got the ones for the idler pressed in and put back together. It's a whole bunch quieter now!
The VFD showed up too, it's good to 3HP so I think I'm going to use that for a larger/better motor for the spindle. Now to find a smaller one (or two) for the table feed and maybe for the surface grinder.
Looks like I got some more electrical to do!
I recommend taking a look at the offerings at the Surplus Center. I've purchased a number of motors and other supplies from them at reasonable prices. The main issue I have with them is their shipping tends to be on the high side.