MetalworkingFun Forum › Machinery › Milling Machines v
Index 40H

Thread Modes
Index 40H
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#10
09-03-2019, 11:12 PM
There are those who claim a surface grinder will produce better finishes if it has a 3 phase motor instead of a single phase one.  Personally I think there are more important factors than the electrical signal going to the motor.
Reply
Thanks given by:


Messages In This Thread
Index 40H - by Vinny - 08-28-2019, 07:33 PM
RE: Index 40H - by Highpower - 08-28-2019, 10:02 PM
RE: Index 40H - by Vinny - 08-28-2019, 10:04 PM
RE: Index 40H - by Highpower - 08-28-2019, 10:16 PM
RE: Index 40H - by Vinny - 08-28-2019, 10:54 PM
RE: Index 40H - by TomG - 08-29-2019, 07:59 AM
RE: Index 40H - by Vinny - 08-29-2019, 12:49 PM
RE: Index 40H - by Dr Stan - 09-02-2019, 03:00 PM
RE: Index 40H - by Vinny - 09-03-2019, 10:42 PM
RE: Index 40H - by Dr Stan - 09-03-2019, 11:12 PM
RE: Index 40H - by awemawson - 09-04-2019, 01:11 AM
RE: Index 40H - by Highpower - 09-04-2019, 11:37 AM
RE: Index 40H - by f350ca - 09-04-2019, 12:18 PM
RE: Index 40H - by Highpower - 09-06-2019, 02:30 PM
RE: Index 40H - by Dr Stan - 09-10-2019, 06:07 PM
RE: Index 40H - by Highpower - 09-10-2019, 08:19 PM
RE: Index 40H - by awemawson - 09-04-2019, 02:28 PM
RE: Index 40H - by Vinny - 09-09-2019, 10:10 PM
RE: Index 40H - by Highpower - 09-09-2019, 10:30 PM
RE: Index 40H - by Dr Stan - 09-10-2019, 08:31 AM
RE: Index 40H - by Vinny - 09-10-2019, 11:37 AM
RE: Index 40H - by arvidj - 09-11-2019, 04:23 PM
RE: Index 40H - by Highpower - 09-12-2019, 02:08 PM
RE: Index 40H - by Dr Stan - 09-11-2019, 05:23 PM
RE: Index 40H - by Vinny - 09-21-2019, 08:08 PM
RE: Index 40H - by Highpower - 09-21-2019, 08:54 PM
RE: Index 40H - by Vinny - 09-21-2019, 09:52 PM



Users browsing this thread: 2 Guest(s)