08-26-2019, 08:48 PM
Heat will only help if its a thermoset plastic and then it may make matters worse. I'd go with Highpower's "more severe approach".
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
Trying to add some attachment points to a plastic cab
Trying to add some attachment points to a plastic cab
|
Trying to add some attachment points to a plastic cab
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Trying to add some attachment points to a plastic cab - by WCarp - 08-24-2019, 07:20 PM
RE: Trying to add some attachment points to a plastic cab - by Highpower - 08-24-2019, 08:46 PM
RE: Trying to add some attachment points to a plastic cab - by Dr Stan - 08-24-2019, 08:52 PM
RE: Trying to add some attachment points to a plastic cab - by EdK - 08-25-2019, 08:52 AM
RE: Trying to add some attachment points to a plastic cab - by Vinny - 08-25-2019, 09:41 AM
RE: Trying to add some attachment points to a plastic cab - by WCarp - 08-26-2019, 12:56 AM
RE: Trying to add some attachment points to a plastic cab - by Highpower - 08-26-2019, 12:54 PM
RE: Trying to add some attachment points to a plastic cab - by Dr Stan - 08-26-2019, 08:48 PM
|
Users browsing this thread: 1 Guest(s)