1865 New Haven Iron Planer
#3
Well thanks, Dave. Smile

Here's a pic of the mill going 'round the bend. I honestly didn't think it would work and expected something to break. Bit of a trick setting the longitudinal position, I adjusted it during the roughing passes to minimize the error. Normally this would be done with the axis of the table and spindle parallel to each other, rather than intersecting like I'm showing here.
   
Reply
Thanks given by:


Messages In This Thread
1865 New Haven Iron Planer - by Sunset Machine - 06-30-2012, 09:50 AM
RE: 1865 New Haven Iron Planer - by DaveH - 06-30-2012, 10:23 AM
RE: 1865 New Haven Iron Planer - by Sunset Machine - 06-30-2012, 10:46 AM
RE: 1865 New Haven Iron Planer - by ETC57 - 06-30-2012, 11:15 AM
RE: 1865 New Haven Iron Planer - by ETC57 - 06-30-2012, 01:48 PM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-06-2012, 04:44 PM
RE: 1865 New Haven Iron Planer - by DaveH - 07-07-2012, 11:49 AM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-07-2012, 08:07 PM
RE: 1865 New Haven Iron Planer - by Mayhem - 07-09-2012, 04:30 AM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-09-2012, 11:16 AM
RE: 1865 New Haven Iron Planer - by stevec - 07-09-2012, 11:31 AM
RE: 1865 New Haven Iron Planer - by DaveH - 07-09-2012, 12:33 PM
RE: 1865 New Haven Iron Planer - by f350ca - 07-09-2012, 02:16 PM
RE: 1865 New Haven Iron Planer - by ETC57 - 07-09-2012, 02:19 PM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-10-2012, 05:27 AM
RE: 1865 New Haven Iron Planer - by stevec - 07-10-2012, 01:31 PM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-14-2012, 03:10 PM
RE: 1865 New Haven Iron Planer - by Rickabilly - 07-15-2012, 04:52 PM



Users browsing this thread: 1 Guest(s)