06-08-2019, 09:37 PM
(06-08-2019, 04:15 PM)EdK Wrote:(06-08-2019, 12:16 PM)lakebom Wrote: Thanks! Verticals would be 4x4s or 4x6s, top would be 4 laminations of 3/4 " plywood, I'm new but have read a bit about the necessity of rigidity and have found noone suggesting using the factory stand as is. Received the unit bolted to a pallet and never realized that he never used the stand, Have an older Delta DP that might like the stand, Thanks again!
4x4 & 4x6s are overkill. I used 2x4s and 2x6s. I had some angle iron inside but I can't remember exactly where I put it. It's been over a decade since I built it.
Ed
Thanks for the input! I have the 4x6 lumber around forever. sheathing sides in plywood sounds good. THank you!