Frankenmill: Bridgeport J head onto Victoria U2
Yes it makes sense to put the tach in the same housing with your VFD controls if you are running one. My mill runs on a rotary phase converter so the DRO arm was just a convenient spot for me to put the MachTach. My lathe on the other hand was a different story. Not in the same housing but close enough.   Big Grin

   
Willie
Reply
Thanks given by:


Messages In This Thread
RE: Frankenmill: Bridgeport J head onto Victoria U2 - by Highpower - 05-28-2019, 11:47 PM



Users browsing this thread: 9 Guest(s)