05-16-2019, 11:24 PM
Use whatever you have on hand and your imagination to bolt the hand wheel down to the table and then bore your hole.
This is a hand wheel I needed to bore and machine driving dogs into it to use on the power feed for the knee on my mill. I have it bolted down to a rotary table/lathe chuck here to cut the dogs but you get the idea. If you only need to bore a hole just go straight on the table with it. If you need more clearance throw some 1-2-3 blocks under it.
This is a hand wheel I needed to bore and machine driving dogs into it to use on the power feed for the knee on my mill. I have it bolted down to a rotary table/lathe chuck here to cut the dogs but you get the idea. If you only need to bore a hole just go straight on the table with it. If you need more clearance throw some 1-2-3 blocks under it.
Willie