MetalworkingFun Forum › Machining › General Metalworking Discussion v
Need a How to VFD

Thread Modes
Need a How to VFD
EdK Offline
Whipping Boy
*******
Posts: 8,863
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#16
05-15-2019, 10:26 PM
(05-15-2019, 09:36 PM)ltlvt Wrote: It does have an auto tune mode. Do you recommend using it or inputting all the info manually.

I believe the auto tune is used after you enter the basic motor information into the VFD. I would do it all manually though. You have more control that way.

Ed
Reply
Thanks given by: ltlvt


Messages In This Thread
Need a How to VFD - by ltlvt - 05-14-2019, 06:50 PM
RE: Need a How to VFD - by EdK - 05-14-2019, 09:40 PM
RE: Need a How to VFD - by ltlvt - 05-14-2019, 09:45 PM
RE: Need a How to VFD - by ltlvt - 05-14-2019, 09:51 PM
RE: Need a How to VFD - by ltlvt - 05-14-2019, 09:54 PM
RE: Need a How to VFD - by Highpower - 05-14-2019, 10:14 PM
RE: Need a How to VFD - by ltlvt - 05-15-2019, 12:58 AM
RE: Need a How to VFD - by Pete O - 05-15-2019, 02:58 AM
RE: Need a How to VFD - by ltlvt - 05-15-2019, 01:49 PM
RE: Need a How to VFD - by Highpower - 05-15-2019, 02:59 AM
RE: Need a How to VFD - by ltlvt - 05-15-2019, 01:53 PM
RE: Need a How to VFD - by Vinny - 05-15-2019, 10:05 AM
RE: Need a How to VFD - by arvidj - 05-15-2019, 04:57 PM
RE: Need a How to VFD - by ltlvt - 05-15-2019, 09:36 PM
RE: Need a How to VFD - by Highpower - 05-15-2019, 09:40 PM
RE: Need a How to VFD - by EdK - 05-15-2019, 10:26 PM
RE: Need a How to VFD - by Hawkeye - 05-15-2019, 10:41 PM
RE: Need a How to VFD - by ltlvt - 05-15-2019, 11:35 PM
RE: Need a How to VFD - by arvidj - 05-16-2019, 02:19 PM
RE: Need a How to VFD - by ltlvt - 05-16-2019, 02:29 PM



Users browsing this thread: 1 Guest(s)