MetalworkingFun Forum › Machining › General Metalworking Discussion v
What size hole for sliding fit?

Thread Modes
What size hole for sliding fit?
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 2 users Like TomG's post:
Highpower (05-10-2019), Wongster (06-02-2019)
#4
05-10-2019, 10:21 AM
Drill the hole about 1mm under and then ream to size. Make sure the drill isn't drilling the hole oversize before going all the way through (I never trust them).

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: Wongster


Messages In This Thread
What size hole for sliding fit? - by Wongster - 05-10-2019, 05:31 AM
RE: What size hole for sliding fit? - by TomG - 05-10-2019, 07:21 AM
RE: What size hole for sliding fit? - by Wongster - 05-10-2019, 10:07 AM
RE: What size hole for sliding fit? - by TomG - 05-10-2019, 10:21 AM



Users browsing this thread: 1 Guest(s)