|
What size hole for sliding fit?
|
|
05-10-2019, 07:21 AM
It depends on how long the part is. More engagement on the shaft equals less wobble. One thousandth inch of clearance would be reasonable for a 1/2" long part and you'll need to ream or bore the hole to hold the precision. Drills won't make a round hole or one held to that tolerance.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
What size hole for sliding fit? - by Wongster - 05-10-2019, 05:31 AM
RE: What size hole for sliding fit? - by TomG - 05-10-2019, 07:21 AM
RE: What size hole for sliding fit? - by Wongster - 05-10-2019, 10:07 AM
RE: What size hole for sliding fit? - by TomG - 05-10-2019, 10:21 AM
|
