MetalworkingFun Forum › Machining › Projects v
Huff & Puff

Thread Modes
Huff & Puff
Doc55 Offline
Freshman
**
Posts: 33
Threads: 11
Joined: Jan 2016
Location: ND
The following 3 users Like Doc55's post:
JScott (04-05-2019), Vinny (04-05-2019), EdK (04-05-2019)
#8
04-05-2019, 03:59 PM
Ok finished up the frame or base still needs some hand work though.
Got the flywheels also done.
Then I got distracted and played with my V-8 engines a bit. LOL
Reply
Thanks given by:


Messages In This Thread
Huff & Puff - by Doc55 - 04-03-2019, 09:38 AM
RE: Huff & Puff - by TomG - 04-03-2019, 01:08 PM
RE: Huff & Puff - by awemawson - 04-03-2019, 03:35 PM
RE: Huff & Puff - by TomG - 04-03-2019, 04:06 PM
RE: Huff & Puff - by Doc55 - 04-03-2019, 06:27 PM
RE: Huff & Puff - by Doc55 - 04-04-2019, 05:00 PM
RE: Huff & Puff - by TomG - 04-04-2019, 07:44 PM
RE: Huff & Puff - by Doc55 - 04-05-2019, 03:59 PM
RE: Huff & Puff - by Doc55 - 04-06-2019, 06:05 PM
RE: Huff & Puff - by Doc55 - 04-10-2019, 09:32 PM
RE: Huff & Puff - by Doc55 - 04-11-2019, 11:23 PM



Users browsing this thread: 2 Guest(s)