04-04-2019, 05:00 PM
Ok didn't get a whole lot done.
I squared up 2 blocks and drilled the connecting rod hole.
From there I put it in a 4 jaw on the lathe and turned up the little boss.
Then went back to the mill drilled the 2 0-80 screw clearance holes and proceeded to mill the block to what you see now.
What is left is the crank hole, radius's and general clean up.
Hope to get them done before the weather gets to nice to stay indoors![[Image: wink.gif]](http://www.modelenginemaker.com/Smileys/default/wink.gif)
Been trying to take pic along with video when I remember.
I squared up 2 blocks and drilled the connecting rod hole.
From there I put it in a 4 jaw on the lathe and turned up the little boss.
Then went back to the mill drilled the 2 0-80 screw clearance holes and proceeded to mill the block to what you see now.
What is left is the crank hole, radius's and general clean up.
Hope to get them done before the weather gets to nice to stay indoors
Been trying to take pic along with video when I remember.