04-04-2019, 05:35 AM
Used up a few hours today getting the slot ready for the T. I opened the top .600 of the slot out to the full width, then ran a 12mm endmill around inside it in .050" deep steps until I had the full depth plus .120" under the T-slot cutter. Nothing left but to cross the T tomorrow. Wish me luck.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.