Frankenmill: Bridgeport J head onto Victoria U2
#73
Coming along nicely Pete. 45 minutes seams long to make a pass, I generally feed a bit on the hard side to keep the chip load up, if too slow the cutter is rubbing and it dulls quicker.
Can see the need for a powered feed. Used a gear head motor I think from a blue print machine to drive the rotary table on one long cut.
[Image: As7y_xRP1Qa-8K5Re_xTMt_V4gXZ6gUS5pL2_JD-...7-h1203-no]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
RE: Frankenmill: Bridgeport J head onto Victoria U2 - by f350ca - 03-27-2019, 07:50 AM



Users browsing this thread: 9 Guest(s)