MetalworkingFun Forum › Machining › General Shop Stuff v
drum door

Thread Modes
drum door
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#7
03-20-2019, 06:34 PM
(03-20-2019, 12:29 PM)TomG Wrote: Do you have room for a vertical lift? You could even lift it vertically as high as possible and then go horizontal for the rest.

In my experience the roll up doors aren't very durable for regular use, unless you go to commercial quality.

Tom

I'd need 160 inches of total height and with 12 ft ceilings I'm short of that.
Reply
Thanks given by:


Messages In This Thread
drum door - by Dr Stan - 03-19-2019, 04:46 PM
RE: drum door - by Vinny - 03-19-2019, 11:08 PM
RE: drum door - by hermetic - 03-20-2019, 07:28 AM
RE: drum door - by TomG - 03-20-2019, 12:29 PM
RE: drum door - by Dr Stan - 03-20-2019, 06:34 PM
RE: drum door - by TomG - 03-20-2019, 08:10 PM
RE: drum door - by Dr Stan - 03-20-2019, 10:41 PM
RE: drum door - by awemawson - 03-20-2019, 04:30 PM
RE: drum door - by Dr Stan - 03-20-2019, 06:32 PM
RE: drum door - by JScott - 03-22-2019, 07:14 AM
RE: drum door - by Dr Stan - 03-22-2019, 10:52 AM



Users browsing this thread: 1 Guest(s)