Frankenmill: Bridgeport J head onto Victoria U2

[Pete O]

(02-27-2019, 08:14 AM)TomG Wrote: You are most likely to get in trouble with the trepanning tool if you try to go too deep in one cut. Limit the depth of cut to the width of the tool or so and then step over and take another cut. Same goes when you are cutting the tee.

Tom

Thanks for that Tom, I will take that on board. The second part of your statement has me puzzled though- the T-slot cutter I have ordered is of a size that will cut the width and depth of the cross part of the 'T' in one pass- is that not how it should be done?