02-23-2019, 04:44 PM
(This post was last modified: 02-23-2019, 05:06 PM by Clifford B..)
The bracket fits my BXA tool post, it has a split UHMW bushing in a split adjustable hole
to set the tension on the indicator nose tube to keep it in place while twisting the face up to read
after flipping from face indicating to radial indicating.
It is designed to keep the indicator on center axis by just dropping it to the bottom
of the tool post without any height adjustment..............
There is a video on youtube by the guy who came up with the idea
If you are familiar with the Hobby Machinist site it can be found in the Shop Made tooling
section on that forum
to set the tension on the indicator nose tube to keep it in place while twisting the face up to read
after flipping from face indicating to radial indicating.
It is designed to keep the indicator on center axis by just dropping it to the bottom
of the tool post without any height adjustment..............
There is a video on youtube by the guy who came up with the idea
If you are familiar with the Hobby Machinist site it can be found in the Shop Made tooling
section on that forum