02-05-2019, 06:30 PM
Since you're already working on the mill, you could cut the barrel to a D shape using a rotary table & tail stock, then cut the rail in the straight leg of the D.
|
Barrel rail for revolvers
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Barrel rail for revolvers - by Velocity Villan - 02-01-2019, 03:36 PM
RE: Barrel rail for revolvers - by Mike E. - 02-01-2019, 06:09 PM
RE: Barrel rail for revolvers - by Dr Stan - 02-01-2019, 11:03 PM
RE: Barrel rail for revolvers - by Dr Stan - 02-01-2019, 11:04 PM
RE: Barrel rail for revolvers - by Mike E. - 02-02-2019, 05:51 AM
RE: Barrel rail for revolvers - by TomG - 02-02-2019, 12:28 PM
RE: Barrel rail for revolvers - by EdK - 02-02-2019, 01:41 PM
RE: Barrel rail for revolvers - by Velocity Villan - 02-05-2019, 06:30 AM
RE: Barrel rail for revolvers - by Velocity Villan - 02-05-2019, 06:36 AM
RE: Barrel rail for revolvers - by Velocity Villan - 02-05-2019, 06:38 AM
RE: Barrel rail for revolvers - by Velocity Villan - 02-05-2019, 06:41 AM
RE: Barrel rail for revolvers - by Dr Stan - 02-05-2019, 10:32 AM
RE: Barrel rail for revolvers - by Roadracer_Al - 02-05-2019, 06:30 PM
|
Users browsing this thread: 1 Guest(s)