MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drilling 95% Tungsten Darts

Thread Modes
Drilling 95% Tungsten Darts
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
#11
12-31-2018, 01:40 PM
If there is no requirement for precision, only weight reduction, I'd suggest abrasives. Perhaps put the weighted tip in the lathe, and use a dremel cut-off tool to cut a ring of known width and depth, which can be calculated for volume.
Reply
Thanks given by:


Messages In This Thread
Drilling 95% Tungsten Darts - by Wongster - 12-15-2018, 02:24 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-15-2018, 11:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:46 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-16-2018, 09:44 AM
RE: Drilling 95% Tungsten Darts - by awemawson - 12-15-2018, 01:17 PM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 06:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:49 AM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 09:24 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-23-2018, 08:36 PM
RE: Drilling 95% Tungsten Darts - by Umahunter - 12-27-2018, 05:01 AM
RE: Drilling 95% Tungsten Darts - by Roadracer_Al - 12-31-2018, 01:40 PM



Users browsing this thread: 1 Guest(s)