Drilling 95% Tungsten Darts

[Wongster]

(12-16-2018, 06:07 AM)Mike E. Wrote: You might want to consider "slightly" shortening the tungsten barrels in the lathe, which should allow you to more easily remove minute amounts of material and accurately establish equal weight for the set.  Also, using wire flight shafts which come in different lengths can reduce weight.

I don't know anything about darts or the game.  I was asked to take off about 2mm depth with a 3mm drill and see how much weight that will take off.  I'll be advised from there if I need to drill a little off from the front hole.

Regards,
Wongster