MetalworkingFun Forum › Machining › General Metalworking Discussion v
What the heck is (was) this?

Thread Modes
What the heck is (was) this?
Clifford B. Offline
Sophmore
***
Posts: 51
Threads: 6
Joined: Jun 2016
Location: Whats left of America
#10
12-13-2018, 07:10 PM
We used the same type of process for hot gluing plywood panels.
4x8 ft. panels and 5x10' 25 panels in a stack and massive multi hydraulic cylinders to
press from underneath......
Reply
Thanks given by:


Messages In This Thread
What the heck is (was) this? - by Pete O - 08-29-2018, 04:27 AM
RE: What the heck is (was) this? - by f350ca - 08-29-2018, 08:58 AM
RE: What the heck is (was) this? - by Pete O - 08-29-2018, 07:17 PM
RE: What the heck is (was) this? - by Mike E. - 08-30-2018, 06:40 PM
RE: What the heck is (was) this? - by Pete O - 08-30-2018, 10:05 PM
RE: What the heck is (was) this? - by awemawson - 08-31-2018, 12:54 AM
RE: What the heck is (was) this? - by Pete O - 09-01-2018, 03:42 AM
RE: What the heck is (was) this? - by terrywerm - 09-03-2018, 10:43 PM
RE: What the heck is (was) this? - by Pete O - 09-04-2018, 08:24 PM
RE: What the heck is (was) this? - by Clifford B. - 12-13-2018, 07:10 PM
RE: What the heck is (was) this? - by frankie - 01-26-2023, 08:45 PM



Users browsing this thread: 1 Guest(s)