MetalworkingFun Forum › Machining › General Metalworking Discussion v
Gates 5m375 polyflex belts.

Thread Modes
Gates 5m375 polyflex belts.
arvidj Offline
Junior
****
Posts: 736
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#9
12-06-2018, 11:12 AM
(12-06-2018, 10:42 AM)Downwindtracker2 Wrote: I didn't look it up, but from my time in maintenance , isn't that a toothed belt ? What is it on.?

It is a V-belt but it has a ribbed top so it gives the impression that it is a timing belt that is inside out Smile .

Not sure what he was going to use it on but it is Grizzly part number P0768007 and that seems to fits their smaller [8x12 and 8x20] lathes and maybe some of their smaller [X2 style] mills.
Reply
Thanks given by:


Messages In This Thread
Gates 5m375 polyflex belts. - by Swarf_Newbie - 10-19-2018, 04:15 PM
RE: Gates 5m375 polyflex belts. - by EdK - 10-19-2018, 07:12 PM
RE: Gates 5m375 polyflex belts. - by Swarf_Newbie - 10-20-2018, 08:10 AM
RE: Gates 5m375 polyflex belts. - by pepi - 12-07-2018, 09:07 AM
RE: Gates 5m375 polyflex belts. - by Swarf_Newbie - 12-25-2018, 07:25 PM
RE: Gates 5m375 polyflex belts. - by arvidj - 10-20-2018, 07:09 PM
RE: Gates 5m375 polyflex belts. - by Mike E. - 10-21-2018, 04:22 AM
RE: Gates 5m375 polyflex belts. - by Swarf_Newbie - 10-21-2018, 06:49 AM
RE: Gates 5m375 polyflex belts. - by Dr Stan - 10-22-2018, 12:19 AM
RE: Gates 5m375 polyflex belts. - by arvidj - 12-06-2018, 11:12 AM
RE: Gates 5m375 polyflex belts. - by rleete - 12-10-2018, 10:33 AM
RE: Gates 5m375 polyflex belts. - by Vinny - 12-26-2018, 03:21 PM
RE: Gates 5m375 polyflex belts. - by Dr Stan - 03-09-2019, 07:36 PM



Users browsing this thread: 2 Guest(s)