11-15-2018, 04:04 PM
I've used Greg's technique many times with good success. Some high strength thread lock or a roll pin will make it permanent and as strong as the original part.
Tom
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
reducing hole size too big for helicoil
reducing hole size too big for helicoil
|
reducing hole size too big for helicoil
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
reducing hole size too big for helicoil - by wawoodman - 11-14-2018, 02:27 PM
RE: reducing hole size too big for helicoil - by Vinny - 11-14-2018, 05:22 PM
RE: reducing hole size too big for helicoil - by f350ca - 11-14-2018, 05:24 PM
RE: reducing hole size too big for helicoil - by Mike E. - 11-14-2018, 06:14 PM
RE: reducing hole size too big for helicoil - by wawoodman - 11-14-2018, 09:33 PM
RE: reducing hole size too big for helicoil - by Hawkeye - 11-14-2018, 11:09 PM
RE: reducing hole size too big for helicoil - by TomG - 11-15-2018, 04:04 PM
RE: reducing hole size too big for helicoil - by Dr Stan - 11-16-2018, 12:37 AM
|
Users browsing this thread: 2 Guest(s)