MetalworkingFun Forum › Machining › General Metalworking Discussion v
reducing hole size too big for helicoil

Thread Modes
reducing hole size too big for helicoil
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 1 user Likes f350ca's post:
Mike E. (11-14-2018)
#3
11-14-2018, 05:24 PM
You could drill the hole larger and thread for say 3/4, then run a 3/4 plug in and drill it and thread for 5/16. I've done that to repair stripped out holes on machinery where I didn't want a helicoil.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
RE: reducing hole size too big for helicoil - by f350ca - 11-14-2018, 05:24 PM



Users browsing this thread: 1 Guest(s)