10-14-2018, 01:13 PM
(This post was last modified: 10-14-2018, 01:16 PM by SnailPowered.)
I have been looking at FlashcutCNC because I found it on a website that talked about doing CNC conversions. It seems to me that I would need their Flashcut software and USB signal generator, then a power supply and the motors I posted above. Looking at the cost of the Flashcut system I will continue looking for a less expensive option. I think that this power supply would be appropriate.
SnailPowered, proud to be a member of MetalworkingFun since Aug 2012.