MetalworkingFun Forum › Machining › Projects v
Disc sander build

Thread Modes
Disc sander build
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#15
10-06-2018, 08:41 AM
Looks good Pete. Do you have a reversing switch on the motor? If you work into a corner you need to be able to reverse the disk for the opposite corner.
I made one for the cabinet shop, you never have to push hard on the material, it eats wood, Im usually working near the center of the disk to control the rate of removal.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: Pete O


Messages In This Thread
Disc sander build - by Pete O - 09-29-2018, 08:04 AM
RE: Disc sander build - by Pete O - 09-29-2018, 08:34 AM
RE: Disc sander build - by TomG - 09-29-2018, 11:22 AM
RE: Disc sander build - by Pete O - 09-29-2018, 05:58 PM
RE: Disc sander build - by the penguin - 09-30-2018, 12:02 PM
RE: Disc sander build - by Pete O - 09-30-2018, 06:50 PM
RE: Disc sander build - by Dr Stan - 09-30-2018, 08:36 PM
RE: Disc sander build - by Pete O - 10-01-2018, 04:26 AM
RE: Disc sander build - by Pete O - 10-03-2018, 01:02 AM
RE: Disc sander build - by Vinny - 10-03-2018, 08:27 AM
RE: Disc sander build - by Pete O - 10-04-2018, 02:34 AM
RE: Disc sander build - by Vinny - 10-04-2018, 04:26 PM
RE: Disc sander build - by Pete O - 10-05-2018, 01:40 AM
RE: Disc sander build - by Pete O - 10-06-2018, 05:01 AM
RE: Disc sander build - by f350ca - 10-06-2018, 08:41 AM
RE: Disc sander build - by TomG - 10-06-2018, 08:42 AM
RE: Disc sander build - by Pete O - 10-06-2018, 06:10 PM
RE: Disc sander build - by Pete O - 10-13-2018, 09:58 PM



Users browsing this thread: 1 Guest(s)