setting up in the 4 jaw

[PeterT]

(06-13-2013, 03:24 PM)the artfull-codger Wrote: Setting up a blank in the 4 jaw to turn a new connecting rod for''albert'' my 4" foster traction engine on my ''mitchell of keighley'' centre lathe,the 4 jaw chuck's 18" diameter, the lathe's 9" centre height X 50" between centres with a gap bed.

Hi there,  I have the exact same lathe which I am presently reconditioning.  Rare as hen's teeth!  

The brass information plate on my lathe's change gearbox is so worn that I cannot read the settings.  Is there a possibility that you could send me a close up photo of the brass information plate on your Mitchell ?

Also - the cover on the drive/driven external change gears of my lathe is missing - can you send a photo of the left end of the lathe so that I can make up something similar.

Also - do you have a manual or any other documentation ?

Would be very grateful,

Regards, PeterT