08-31-2018, 12:54 AM
Cut it into slices and surface grind top and bottom to make several sets of parallels
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
|
What the heck is (was) this?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
What the heck is (was) this? - by Pete O - 08-29-2018, 04:27 AM
RE: What the heck is (was) this? - by f350ca - 08-29-2018, 08:58 AM
RE: What the heck is (was) this? - by Pete O - 08-29-2018, 07:17 PM
RE: What the heck is (was) this? - by Mike E. - 08-30-2018, 06:40 PM
RE: What the heck is (was) this? - by Pete O - 08-30-2018, 10:05 PM
RE: What the heck is (was) this? - by awemawson - 08-31-2018, 12:54 AM
RE: What the heck is (was) this? - by Pete O - 09-01-2018, 03:42 AM
RE: What the heck is (was) this? - by terrywerm - 09-03-2018, 10:43 PM
RE: What the heck is (was) this? - by Pete O - 09-04-2018, 08:24 PM
RE: What the heck is (was) this? - by Clifford B. - 12-13-2018, 07:10 PM
RE: What the heck is (was) this? - by frankie - 01-26-2023, 08:45 PM
|
Users browsing this thread: 2 Guest(s)