|
mill vise
|
|
07-28-2018, 09:28 AM
(This post was last modified: 07-28-2018, 09:34 AM by Mike E..
Edit Reason: spell
)
Here is another design. I just acquired this used " Carver T-500 " two piece vise set. The British company has two different models, this is the smaller set which fits my moderately sized mill. Very well made. and came with slide on swarf covers. The jaws provide both end clamping and also a downward gripping feature.
Mike
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: mill vise - by Hawkeye - 02-18-2018, 11:17 AM
RE: mill vise - by SteveG - 02-18-2018, 07:41 PM
RE: mill vise - by f350ca - 02-18-2018, 08:53 PM
RE: mill vise - by pepi - 02-18-2018, 10:15 PM
RE: mill vise - by randyc - 02-18-2018, 11:57 PM
RE: mill vise - by the penguin - 02-19-2018, 11:18 AM
RE: mill vise - by the penguin - 02-19-2018, 11:27 AM
RE: mill vise - by randyc - 02-19-2018, 04:18 PM
RE: mill vise - by randyc - 02-19-2018, 05:39 PM
RE: mill vise - by SteveG - 02-19-2018, 06:01 PM
RE: mill vise - by randyc - 02-19-2018, 10:24 PM
RE: mill vise - by Vinny - 02-20-2018, 12:04 AM
RE: mill vise - by Dr Stan - 03-20-2018, 11:57 AM
RE: mill vise - by 2Young2 - 03-18-2018, 11:14 AM
RE: mill vise - by Vinny - 03-20-2018, 02:13 PM
RE: mill vise - by Dr Stan - 03-20-2018, 03:02 PM
RE: mill vise - by Vinny - 03-20-2018, 06:36 PM
RE: mill vise - by Dr Stan - 03-20-2018, 08:54 PM
RE: mill vise - by EdK - 03-21-2018, 03:51 PM
RE: mill vise - by Vinny - 03-20-2018, 10:50 PM
RE: mill vise - by Dr Stan - 03-21-2018, 02:10 PM
RE: mill vise - by Mike E. - 07-28-2018, 09:28 AM
RE: mill vise - by Vinny - 07-28-2018, 11:45 AM
RE: mill vise - by Highpower - 07-31-2018, 03:35 PM
RE: mill vise - by Highpower - 07-28-2018, 04:15 PM
RE: mill vise - by Mike E. - 07-29-2018, 05:48 AM
RE: mill vise - by Vinny - 07-31-2018, 06:35 PM
RE: mill vise - by big o - 08-05-2021, 06:08 PM
RE: mill vise - by Vinny - 08-05-2021, 09:35 PM
RE: mill vise - by Dr Stan - 08-07-2021, 01:36 PM
RE: mill vise - by Vinny - 08-09-2021, 09:16 PM
|
