07-26-2018, 08:31 PM
I have a project coming up that I will need to turn a few inches on the ends of some long pieces of 1/2” and 1” OD tubing. The tubing will be around 4’ long. So there will be a lot of material sticking out of the headstock on my lathe.
What do you guys use to support the material sticking out from whipping around?
I’m looking for some ideas of something that I can build instead of something that is bought.
Thanks
Trevor
What do you guys use to support the material sticking out from whipping around?
I’m looking for some ideas of something that I can build instead of something that is bought.
Thanks
Trevor
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO