06-30-2018, 07:06 PM
Don't look at my drawing too critically. It's not complete and even if it was I only put in enough detail to get me through making it.
I'll be making a matching set of these for mounting a newer Harley fender to a set of '82 front sliders. The part will be somewhat visible. I was planning to round off certain edges and I figured the easiest way to do that would be a concave end mill with a 1/8" radius. CNC - no problem. Manual mill with rotary table, a bit more.
![[Image: FrontFenderMounts.jpg]](http://www.arcaneiron.com/shovelbuild/FrontFenderMounts.jpg)
Comments?
Thanks,
-Ron
I'll be making a matching set of these for mounting a newer Harley fender to a set of '82 front sliders. The part will be somewhat visible. I was planning to round off certain edges and I figured the easiest way to do that would be a concave end mill with a 1/8" radius. CNC - no problem. Manual mill with rotary table, a bit more.
Comments?
Thanks,
-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper