06-07-2018, 10:25 AM
I just went and asked the machinists here at work, because I didn't even know what nod is on a mill.
Not one of the machinists here had ever used it, and a couple of the less experienced guys didn't even know what I was talking about.
The most experienced old timer says he doesn't even like to use the tilt, because he dislikes having to tram the head afterwards, and instead uses a sine vise.
Not one of the machinists here had ever used it, and a couple of the less experienced guys didn't even know what I was talking about.
The most experienced old timer says he doesn't even like to use the tilt, because he dislikes having to tram the head afterwards, and instead uses a sine vise.
Full of ideas, but slow to produce parts