MetalworkingFun Forum › Machining › How-To's v
No Transfer Punches ?

Thread Modes
No Transfer Punches ?
Brian Offline
Junior
****
Posts: 437
Threads: 24
Joined: Sep 2012
Location: Sicily
The following 4 users Like Brian's post:
Highpower (04-24-2018), EdK (04-24-2018), arvidj (04-24-2018), SteveG (04-26-2018)
#14
04-24-2018, 01:03 AM
In the middle of a job with no transfer punch???
Find a drill that fits the hole drop it in and tap lightly now turn the drill 90° and tap again and you will have a neat little cross to show your center.
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:


Messages In This Thread
No Transfer Punches ? - by randyc - 08-25-2017, 05:37 PM
RE: No Transfer Punches ? - by f350ca - 08-25-2017, 07:13 PM
RE: No Transfer Punches ? - by randyc - 08-25-2017, 08:58 PM
RE: No Transfer Punches ? - by TomG - 08-26-2017, 02:37 PM
RE: No Transfer Punches ? - by wawoodman - 08-30-2017, 01:30 PM
RE: No Transfer Punches ? - by Highpower - 08-30-2017, 01:59 PM
RE: No Transfer Punches ? - by Alphonse - 08-30-2017, 02:46 PM
RE: No Transfer Punches ? - by kwoodhands - 02-09-2018, 06:10 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 08:22 PM
RE: No Transfer Punches ? - by randyc - 08-30-2017, 09:23 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 09:26 PM
RE: No Transfer Punches ? - by Mayhem - 08-31-2017, 07:46 AM
RE: No Transfer Punches ? - by randyc - 08-31-2017, 04:54 PM
RE: No Transfer Punches ? - by Brian - 04-24-2018, 01:03 AM



Users browsing this thread: 1 Guest(s)