Advice on bending 1/4" flat bar steel

Thread Modes

Advice on bending 1/4" flat bar steel

Vinny

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

The following 4 users Like Vinny's post:
EdK (04-13-2018), f350ca (04-14-2018), Brett6366 (04-17-2018), Roadracer_Al (04-21-2018)

04-13-2018, 07:49 PM

In case Brett's not aware, the "log splitter" Greg's referring to does a little more than just splitting a log. Actually about the only thing it doesn't do is chop down the tree!

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Advice on bending 1/4" flat bar steel - by Brett6366 - 04-10-2018, 07:28 AM

RE: Advice on bending 1/4" flat bar steel - by TomG - 04-10-2018, 11:26 AM

RE: Advice on bending 1/4" flat bar steel - by f350ca - 04-10-2018, 12:41 PM

RE: Advice on bending 1/4" flat bar steel - by Brett6366 - 04-10-2018, 08:15 PM

RE: Advice on bending 1/4" flat bar steel - by f350ca - 04-10-2018, 08:52 PM

RE: Advice on bending 1/4" flat bar steel - by Brett6366 - 04-11-2018, 06:53 AM

RE: Advice on bending 1/4" flat bar steel - by pepi - 04-12-2018, 06:43 AM

RE: Advice on bending 1/4" flat bar steel - by Brett6366 - 04-13-2018, 07:27 PM