MetalworkingFun Forum › Machining › General Metalworking Discussion v
Advice on bending 1/4" flat bar steel

Thread Modes
Advice on bending 1/4" flat bar steel
Brett6366 Offline
Freshman
**
Posts: 5
Threads: 2
Joined: Feb 2018
Location: USA
The following 1 user Likes Brett6366's post:
f350ca (04-14-2018)
#8
04-13-2018, 07:27 PM
(04-12-2018, 06:43 AM)pepi Wrote: Could always automate that tool. Would not think that would be all that hard to do.

Pretty sure Greg would have some good input on that subject. Thinking about the log splitter he built

the other,
Greg

  We may be bringing this up for re-discussion this in the near future!
Reply
Thanks given by:


Messages In This Thread
RE: Advice on bending 1/4" flat bar steel - by Brett6366 - 04-13-2018, 07:27 PM



Users browsing this thread: 4 Guest(s)