MetalworkingFun Forum › Machining › Metrology v
Gage blocks on the cheap...

Thread Modes
Gage blocks on the cheap...
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#5
03-28-2018, 05:40 PM
No doubt a beter way to go Willie. I bought a set of Chinese ones from KBC tools. Then I bought a set of Mahr 1/10ths micrometers. Those blocks are all over the place or the Germans can't make micrometers. Your guess.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Gage blocks on the cheap... - by Highpower - 03-27-2018, 10:34 PM
RE: Gage blocks on the cheap... - by Mike E. - 03-28-2018, 03:37 AM
RE: Gage blocks on the cheap... - by TomG - 03-28-2018, 08:23 AM
RE: Gage blocks on the cheap... - by Highpower - 03-28-2018, 01:02 PM
RE: Gage blocks on the cheap... - by f350ca - 03-28-2018, 05:40 PM
RE: Gage blocks on the cheap... - by Pete O - 03-28-2018, 08:28 PM
RE: Gage blocks on the cheap... - by Highpower - 03-28-2018, 09:14 PM
RE: Gage blocks on the cheap... - by randyc - 03-28-2018, 10:43 PM
RE: Gage blocks on the cheap... - by TomG - 03-29-2018, 08:31 AM
RE: Gage blocks on the cheap... - by Vinny - 03-29-2018, 09:40 AM
RE: Gage blocks on the cheap... - by f350ca - 03-28-2018, 11:19 PM
RE: Gage blocks on the cheap... - by randyc - 03-29-2018, 06:48 PM
RE: Gage blocks on the cheap... - by Highpower - 03-29-2018, 02:26 AM
RE: Gage blocks on the cheap... - by 4gsr - 03-30-2018, 09:19 AM
RE: Gage blocks on the cheap... - by randyc - 03-30-2018, 03:34 PM
RE: Gage blocks on the cheap... - by 4gsr - 03-30-2018, 04:48 PM
RE: Gage blocks on the cheap... - by randyc - 03-30-2018, 05:13 PM



Users browsing this thread: 3 Guest(s)