MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] DRO Questions

Thread Modes
Help DRO Questions
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Highpower (03-28-2018)
#14
03-27-2018, 04:19 PM
(03-27-2018, 12:02 PM)Highpower Wrote: Still I don't any regret having bought the mini-lathe because I learned a LOT by getting some hands on time with it.

My exact same experience with the HF 7x10 mini-lathe.

Ed
Reply
Thanks given by:


Messages In This Thread
DRO Questions - by Cross Slide - 03-25-2018, 05:35 PM
RE: DRO Questions - by TomG - 03-25-2018, 07:24 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 08:42 PM
RE: DRO Questions - by TomG - 03-25-2018, 09:02 PM
RE: DRO Questions - by Highpower - 03-25-2018, 08:57 PM
RE: DRO Questions - by kwoodhands - 03-26-2018, 05:54 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:01 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:49 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:46 AM
RE: DRO Questions - by Cross Slide - 03-26-2018, 06:56 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:40 PM
RE: DRO Questions - by Cross Slide - 03-26-2018, 11:13 PM
RE: DRO Questions - by Highpower - 03-27-2018, 12:02 PM
RE: DRO Questions - by EdK - 03-27-2018, 04:19 PM
RE: DRO Questions - by Robert - 03-29-2018, 06:47 PM
RE: DRO Questions - by Vinny - 03-29-2018, 09:25 PM
RE: DRO Questions - by Cross Slide - 03-30-2018, 06:28 PM
RE: DRO Questions - by terrywerm - 04-01-2018, 07:24 AM



Users browsing this thread: 4 Guest(s)