MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] DRO Questions

Thread Modes
Help DRO Questions
Cross Slide Offline
Sophmore
***
Posts: 109
Threads: 24
Joined: Aug 2016
Location: Regina Saskatchewan Canada
#7
03-25-2018, 09:49 PM
That now makes complete sense. Thanks for the info guys.
I believe that was the only thing that I didn't understand on the lathe setup.
The DRO on the mill has a bolt circle and grid pattern function that I want to learn how to use.
I haven't looked at how to set them up yet. Not sure if it's a easy task or not.
Trevor
Reply
Thanks given by:


Messages In This Thread
DRO Questions - by Cross Slide - 03-25-2018, 05:35 PM
RE: DRO Questions - by TomG - 03-25-2018, 07:24 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 08:42 PM
RE: DRO Questions - by TomG - 03-25-2018, 09:02 PM
RE: DRO Questions - by Highpower - 03-25-2018, 08:57 PM
RE: DRO Questions - by kwoodhands - 03-26-2018, 05:54 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:01 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:49 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:46 AM
RE: DRO Questions - by Cross Slide - 03-26-2018, 06:56 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:40 PM
RE: DRO Questions - by Cross Slide - 03-26-2018, 11:13 PM
RE: DRO Questions - by Highpower - 03-27-2018, 12:02 PM
RE: DRO Questions - by EdK - 03-27-2018, 04:19 PM
RE: DRO Questions - by Robert - 03-29-2018, 06:47 PM
RE: DRO Questions - by Vinny - 03-29-2018, 09:25 PM
RE: DRO Questions - by Cross Slide - 03-30-2018, 06:28 PM
RE: DRO Questions - by terrywerm - 04-01-2018, 07:24 AM



Users browsing this thread: 1 Guest(s)