MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] DRO Questions

Thread Modes
Help DRO Questions
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#6
03-25-2018, 09:02 PM
(03-25-2018, 08:42 PM)Cross Slide Wrote: Thanks Tom. 
If I’m getting what your says. 
This would be used on your kneeling tool where the main body has all the measurement set off the center point?
Trevor

Wherever your measurements are taken from is absolute zero on the part.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
DRO Questions - by Cross Slide - 03-25-2018, 05:35 PM
RE: DRO Questions - by TomG - 03-25-2018, 07:24 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 08:42 PM
RE: DRO Questions - by TomG - 03-25-2018, 09:02 PM
RE: DRO Questions - by Highpower - 03-25-2018, 08:57 PM
RE: DRO Questions - by kwoodhands - 03-26-2018, 05:54 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:01 PM
RE: DRO Questions - by Cross Slide - 03-25-2018, 09:49 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:46 AM
RE: DRO Questions - by Cross Slide - 03-26-2018, 06:56 PM
RE: DRO Questions - by Highpower - 03-26-2018, 09:40 PM
RE: DRO Questions - by Cross Slide - 03-26-2018, 11:13 PM
RE: DRO Questions - by Highpower - 03-27-2018, 12:02 PM
RE: DRO Questions - by EdK - 03-27-2018, 04:19 PM
RE: DRO Questions - by Robert - 03-29-2018, 06:47 PM
RE: DRO Questions - by Vinny - 03-29-2018, 09:25 PM
RE: DRO Questions - by Cross Slide - 03-30-2018, 06:28 PM
RE: DRO Questions - by terrywerm - 04-01-2018, 07:24 AM



Users browsing this thread: 2 Guest(s)