03-16-2018, 12:48 PM
The dies appear to be open (no decapping rod) so any crud would seem to fall through. Even right side up, I still need to clean out any built up case lube / dust / dirt from my dies now and then.
Nice looking press, but I'm still left wondering the full purpose of the design? Does the upper ram even have a shell holder?
By the way - I have that same machinist hammer I made back in high school metal shop, although mine is a bit worse for wear after 40+ years of use.
Nice looking press, but I'm still left wondering the full purpose of the design? Does the upper ram even have a shell holder?
By the way - I have that same machinist hammer I made back in high school metal shop, although mine is a bit worse for wear after 40+ years of use.
Willie