MetalworkingFun Forum › Machining › Projects v
Mud Lathe

Thread Modes
Mud Lathe
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#8
03-08-2018, 06:17 PM
Incredible job on the gears Pete.
So you angle the indexing head to the table axis to make the second and third cut ? Makes sense, how did you measure the angle ?
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Mud Lathe - by Pete O - 03-08-2018, 02:56 AM
RE: Mud Lathe - by Pete O - 03-08-2018, 03:25 AM
RE: Mud Lathe - by Pete O - 03-08-2018, 06:00 AM
RE: Mud Lathe - by TomG - 03-08-2018, 10:25 AM
RE: Mud Lathe - by Vinny - 03-08-2018, 11:24 AM
RE: Mud Lathe - by Pete O - 03-08-2018, 03:28 PM
RE: Mud Lathe - by Pete O - 03-08-2018, 04:34 PM
RE: Mud Lathe - by f350ca - 03-08-2018, 06:17 PM
RE: Mud Lathe - by Pete O - 03-08-2018, 08:25 PM
RE: Mud Lathe - by f350ca - 03-08-2018, 09:53 PM
RE: Mud Lathe - by Pete O - 03-09-2018, 01:45 AM
RE: Mud Lathe - by Pete O - 03-11-2018, 07:11 PM
RE: Mud Lathe - by TomG - 03-11-2018, 07:58 PM
RE: Mud Lathe - by Pete O - 03-11-2018, 10:14 PM
RE: Mud Lathe - by Pete O - 04-14-2018, 10:21 PM
RE: Mud Lathe - by Roadracer_Al - 04-21-2018, 02:15 PM
RE: Mud Lathe - by Pete O - 04-22-2018, 06:51 AM



Users browsing this thread: 2 Guest(s)